Project Description
!!!!!SOLD!!!!! This is a 1/3 scale high relief, hand carved, and silver wire inlaid, walnut casing made by Miniart to fit one of their 1/3 scale 1894 Winchester trapper carbines. The top is carved with a growling bear in an oval panel scene, with oak leaf clusters on each side. There are silver wire inlays on each end of the top, front, and back, and on the back of each side. Push button latch. The bottom with inset red cloth. The interior is French fit and covered in a dark burgundy velour. There is a walnut block with five holes to hold dummy cartridges. This case is made for a shorter barrel trapper carbine than the one I currently have listed on my website, but it could easily be refitted to fit any length 1/3 scale Winchester 1894 including the full length rifles, or any other similar sized rifle. Would be great to gut the bottom and refit it for one of the 1/3 scale Miniart Mosin Nagant rifles or carbines. Outside dimensions 16 1/2″ long X 4″ wide X 1 3/4″ deep. Interior dimensions 15 1/2″ X 2 15/16″ X about 1 1/4″. There is a bruise on each rear top corner where the corner has been hit and kind of rounded, not real noticeable since it’s on the rear. !!!!!SOLD!!!!! For CE
