Project Description
!!!!!SOLD!!!!! This is a 1/2 scale Smith & Wesson Model 36, swing out cylinder .38 caliber five shot revolver made by Miniart in Moscow, Russia. 3 1/4″ long overall with a 7/8″ barrel. Blue finish, two piece checkered walnut grips with blue steel escutcheons and a single screw entering from the left side. Both grips with a nickel colored round S & W medallion inlaid near the top. The ramp front sight with serrations on it’s top edge. Rear frame notch rear sight. Checkered cylinder release. as is the front of the cylinder pin. The left side of the barrel stamped “SMITH & WESSON”. The left rear of the frame stamped with the S & W logo with “TRADE” above and “MARK, REG. U.S. PAT. OFF” below. The right front of the frame marked “MADE IN U.S.A., MARCAS REGISTRADAS, SMITH & WESSON, SPRINGFIELD, MASS” in four lines. The number “011” stamped into the bottom of the buttstrap. Complete with four solid steel dummy cartridges. Miniart only made a very few of these revolvers and they are rare. This is only the fourth one I have ever had the opportunity to offer for sale in almost 17 years, and is the highest serial number I’ve seen. !!!!!SOLD!!!!!
