Project Description
!!!!!SOLD!!!!! This is a 1/2 scale Smith & Wesson Model 36, swing out cylinder .38 caliber five shot revolver made by Miniart in Moscow, Russia. 3 1/4″ long overall with a 7/8″ barrel. Blue finish, two piece checkered walnut grips with blue steel escutcheons and a single screw entering from the left side. Both grips with a nickel colored S & W medallion inlaid near the top. The ramp front sight with serrations on it’s top edge. Rear frame notch rear sight. Checkered cylinder release. as is the front of the cylinder pin. the left side of the barrel stamped “SMITH & WESSON”. The left rear of the frame stamped with the S & W logo with “TRADE” above and “MARK, REG. U.S. PAT. OFF” below. The right front of the frame marked “MADE IN U.S.A., MARCAS REGISTRADAS, SMITH & WESSON, SPRINGFIELD, MASS” in four lines. The number “003” stamped into the bottom of the buttstrap. The number “3” engraved into the right side of the cylinder crane. Complete with four solid steel dummy cartridges. Miniart only made a very few of these revolvers and they are rare. This is only the third one I have ever seen in almost 27 years. Stock # ES-34. !!!!!SOLD!!!!!
