Project Description

!!!!!SOLD!!!!!  This is an antique five shot 4 mm pinfire, “THE FIVE ACES”, ring gun, by an unknown maker, probably made in France or Belgium in the 1860’s to 1880’s.  The ring looks to be silver, but shows no hallmarks.  The back side of the ring engraved “THE FIVE ACES” along with some vine & leaf engraving.  The balance of the parts are fire blued steel.  The interior of the ring measures .814.  The cylinder measures .443 tall X .595 in diameter.  Complete with an extra cylinder, the original case, & a small screwdriver for removing the cylinder for loading.  The hinged top case is brown pebble grain leather on the outside.  The interior bottom French fit and covered in a dark green velour.  The interior top is padded and covered in a cream colored silk, with the markings “THE EMPIRE’S LARGEST JEWELER, H. SAMUEL, MARKET STREET MANCHESTER” in 6 lines.  This ring gun has an unusual feature which is the addition of a hammer spur.  I suspect the hammer may have been made that way to increase the mass of the hammer, making for a more powerful strike to the firing pin.  The cylinder is manually indexed, with a spring cylinder stop to align the chamber, & firing pin, to the hammer.  There is a knurled ring at the top of the cylinder sides to aid in grasping the cylinder to rotate it.  Near mint condition showing only very minor blue wear to the sharp edges.  The case is excellent showing only minor wear to the edges and corners.

The included 4mm pinfire dummy cartridges were made for ring guns by Carmen Gianforte, a master miniature firearms maker, master machinist, and also a past President of the Miniature Arms Society.  I will include the full 10 with this ring gun cased set, filling every original hole for a cartridge in the case.  The cartridges are .156″ in diameter, .306″ long, and have a small lead ball seated flush with the case mouth.  Since all these ring guns, and their cartridges, are hand made, I do not guarantee them to fit in the cylinder of the ring.  They are made to fill the holes in the case.  Each dummy cartridge takes 39 steps and over an hour to make by a very skilled machinist, who would normally get $75.00 – $125.00+/hour if he wasn’t retired and a friend of mine!  Additional dummies can be purchased for $40.00/each when available.

Price:  $4,500.00.